5400 Foam Miter Cut

5400-2 with 5610 Back Table System

The Foam Miter Cut can be used in the shop or on the job site. The 5400 cuts expanded polystyrene (EPS) extruded polystyrene (XPS), and Styrofoam.

Foam Miter Cut Features

Polished ground rods for smooth bearing travel
Secure heavy duty leg hinge supports
16 gauge sheet metal top for long life
Top quality Linemaster foot switch
16 precision, maintenance free sealed ball bearings for effortless cutting
Harp is 1-3/8″ x 2″ x 1/8″ 6061T6 aluminum for lifelong durability
9 detent harp settings plus harp-lock location to cut any angle in either direction
Cable alignment system for perfectly parallel cuts and tapered columns
Two aluminum side fences with quick release for cuts of 90 to 40 degrees for all your miter and compound miter needs
Large knobs lock harps
Harp tilts both directions for ease of use
Full 48″ back gauge provides large cutting capacity
110 or 220 volt input with safety isolated transformer

Shaded areas indicated were created with the 5400. Create straight or tapered columns. (non-shaded areas were cut using the 5300, Arch-Base)

MiterCut 5400: Available in two different setups. The MiterCut 5400 is the basic model capable of cutting sheets and compound miters with the use of the angle guides on each side.
MiterCut 5400-2: Comes with the template holder and counter weights. The template holder takes custom designed templates for mouldings or columns while the counter weights insure smooth fluid harp movement while following the template. Create custom designs for columns or mouldings using a hardboard template pattern of your design. Template may be up to 26″ radius x 1/4″ thick (66cm x 122cm x 6.35mm).
Outfeed Support 5610: Comprised of two outfeed tables with leveling feet and a cam-locking fence for fast, accurate cuts. Fence includes a hairline indicator and measuring scale to increase the guillotine’s performance. This support system has sheet metal tops with 48″ (122cm) back fence capacity.